Testosterone Injections

Testosterone Injections For Bodybuilding

How to make Testosterone Injections of steroids?

There are several things you need to know when Testosterone Injections starting to stab anabolic steroids. The most important thing is always to remember that you need to be clean and keep hygiene. Always use new sealed syringes. Never use old syringes and, especially, strangers. Injection rulesSimple, but you need to keep them constantly. Make sure that the site of the injection is clean and correctly selected (cheat “where to stab steroids”). Get a new syringe out of the package, put a needle on it and make sure that it sticks to the syringe. Under the rules of injection, wipe the top of the bottle (if you use a steroid in a vial) with a piece of cloth soaked in alcohol to make sure that it is sterile. Remove the protective case from the needle, insert the needle into the vial, turn it upside down and fill the syringe with the right amount of fluid plus a little bit more than that. Now, as the rules of injection say, tap your finger on the syringe to collect all the air bubbles in the top of the syringe into one, then enter that extra part of the fluid taken over, back into the vial and the air will go away with it. With the help of another, impregnated with alcohol, cloths wipe the place,

Testosterone InjectionsTry not to touch the needle with anything. it can stain the needle and lead to serious problems with the infection. If a little liquid escapes from the needle, do not touch or wipe it. it will help lubricate the injection site. Now, holding the syringe like a dart, at an angle of 90 degrees, bring the needle deep into the muscle. Then pull the plunger back – if the blood gets into the syringe, then you have hooked the blood vessel and you should take out the needle and try again. If there is no blood, for example, injecting insulin, slowly (so that there are no painful sensations), press down on the needle until all the fluid is in the muscle. Finally, quickly remove the needle and massage the injection site with another sterile cloth (this will reduce bleeding and eliminate discomfort in the following days). Put a protective shell on the needle, say, after injections of insulin , and remove it from the syringe. Try not to inject more than 2 ml into the same place and more often 2 times a week. Remember: never use a syringe and needle again.

Where to stab steroids?

Anabolic steroids, both oil-based and water-based, should be administered intramuscularly (deep into the muscle tissue). The most typical places for injections are the buttocks, the outer part of the thigh and the delta. These muscles are most often used because of their thickness. They contain more fibers and an extensive fascia. The fascia is the connective tissue that surrounds and divides the muscles. In connection with this, the steroid injected has a large suction surface.

During intramuscular injections and other injections of the steroid, the goal is to insert the needle as deeply as possible and not to touch either the nerve or the blood vessel. The best place for injections is the gluteus medius, located in the upper outer part of the buttocks (see photo). It is preferred because of its thickness and the presence of a small number of nerves. When injected into this muscle, the probability of getting into the vessel or sciatic nerve that passes through the lower and middle of the buttocks is very low. If it is damaged, you will feel a great pain and can be temporarily paralyzed.

Injecting steroids, what kind of syringe to take?

Choosing the right syringe is very important. First of all for injection of steroids , you will need a syringe of the right amount. The liquid is measured in cubic millimeters. Secondly, you need a needle deep in the muscle for optimal absorption, sufficient diameter to allow oil to pass, but not too wide to get injured. There are many different types of syringes for injecting steroids: some are longer, some are thicker. Most bodybuilders prefer 2-3ml syringes. If you are not sure which syringe to choose, consult the pharmacist.

Basic rules of injection:

  1. Determine in advance what you are going to stab, in what quantities, what needles need it for and where you will inject steroids (into the buttock or thigh).
  2. Be sure to check the expiration date of the drugs used.
  3. Gather together everything you need for injections – drugs, needles, syringes, alcohol, cotton swabs, etc.
  4. Wash with soap and hands and place where you will do steroid injections, injections, soap completely washed away.
  5. If the preparation is packaged in a sealed vial, remove the Testosterone Injections protective cap and wipe the rubber cap with alcohol. If the drug is in the ampoule, take a thin file and gently, in a circular motion, make a nail around the neck. Then, with your own movement, break off the neck of the ampoule. At the same time, in order not to injure your hands, you can also wrap the ampoule with a napkin.
  6. A syringe and needle, if you decide to inject injection steroids, should be new or properly sterilized. If you use the drug in a vial, pull the plunger of the syringe to a volume equal to the volume of the drug that you will use, insert the needle into the vial through the rubber cap and press the plunger, releasing the air into the vial. Reaching the end, turn the vial upside down and slowly pull the plunger, drawing the drug into the syringe to the desired amount. Then pull the needle out of the bubble. If you use the drug in an ampoule, insert the needle into the open ampoule and draw the drug into the syringe to the correct amount, then pull the needle out of the ampoule.
  7. Turning the needle up, tap on the walls of the syringe to get rid of the air bubbles that could remain on the inner walls of the cylinder. In some cases, if an oily solution is used, it may take ten minutes. The oil solution needs to be held in the hand, so that it heats up and becomes more liquid. When all the bubbles rise to the needle, gently press the plunger, so that the drug begins to exit the needle. Wipe the injection site with cotton wool soaked in alcohol.
  8. While holding the syringe for injection of steroids, like a pencil, bring the needle into the injection site with one quick push. Enter the needle three-quarter lengthwise, no further; if the needle breaks, it will be very difficult to pull it out.
  9. When you have correctly inserted the needle, pull out the plunger slightly. If the blood comes easily into the syringe, then you are in a blood vessel and you need to change the injection site. If there is no blood, then, where steroids are injected, press the plunger, injecting the drug. The input speed is approximately 15 seconds per cube. see, slowly and accurately.
  10. When the entire drug is injected, pull the needle out quickly. Cleanse, moistened with alcohol, wipe and massage the place of injection. It can bleed a little, do not be Testosterone Injections scared, it’s normal.
  11. At the injection site, where sticks are no longer necessary, you can put an antibiotic on a tampon and fix it with a plaster. Dispose of all residues left from the procedure.

This, perhaps all the basic and private advice. Injectable steroids are not so difficult to use, but are undoubtedly effective. If you screw up when they are introduced, then you will not have problems later. Not to mention the waste of not cheap drugs. Carefully approach the question and then there is nothing to be afraid of.

Injections of gonadotrapine.

anabolic steroidsFirst open the ampoule with the solvent (as read open above). Type the solvent from the ampoule into the syringe, then open the ampoule (ampoules) with the powder of the preparation and slowly pressing the plunger, add the solvent to the powder. Gently mix the contents, stir in circular motions, DO NOT TRACE. The solution of gonadotrapine injection should be clear and without undissolved drug particles. Now put the solution in the syringe for the injection. Needle while you need to change to a new one. Remove all air bubbles from the syringe of the gonadotrapine injection, wipe the injection site with cotton wool soaked in alcohol, then inject the needle into the injection site. Usually this is the top of the thigh or buttock. Make sure that the needle does not enter the blood vessel (see above). If you still got – carefully remove the needle after injections of gonadotrapine, throw the syringe with the contents and start all over again with a new syringe, needles and preparation. After injection, the injection site can be closed with a band-aid, if necessary.

Insulin injections.

Insulin, insulin injections , can be injected into any place on the body where Testosterone Injections there is a fatty layer. The abdomen area is the most common place for insulin injections. Nurses, however, make insulin injections and elsewhere – the buttocks, thighs, upper parts of the hands … When injecting insulin, it is important to remember that every next injection should be at least 3 centimeters from the previous one, if this is not taken into account, at the injection site, insulin injections can form thickening of the skin and scars.